CONDOR

My Condor sleept five months becouse my heavy illness. As I tried again to start my loved Condor which worked very fine before my illness, it made fatal problem. As I started it, appeared the leading picture with menu but a little window too: "it is not a valid integer value. After then my Condor loaded in and seemed to work correct, but at choosing the plane said, it is not activated. And did so with other planes of all planepacks. Because I have the original codes which I got at buying the planepacks, I write this in, but my Condor did accepted no any.

What is the problem?
Is it possible that the codes after a long sleeptime became obsolete?
Or what and what to do?

Can somebody help me?

Thank you.

Did you upgrade v 1.15 ?

If not, then you should do this, then retry your plane packs.

_________________
Chris Wedgwood,
Condor Team

I am having the same problem as jega. I replaced my old computer and tried to reinstall from my original images.
Starting with 1.1.2 I got the error dialog box
" is not a integer value

I've deleted and reinstalled and upgraded to 1.14 and 1.15

Looks like it may start after I assign my pedals as the rudder control if that helps

Run Condor as administrator

_________________
PH-2729, WS

Running as admin did not help. It's as if a config file has been corrupted. The simulator actually seems to run if I ignore the error however I have only done a superficial test. I never had this problem in the original installation.

Mine did this after checking "auto rudder", it appears that all parameters under "setup" were lost, moving all sliders and entering the parameters fixed the problem ... strange.